BUD Industries IPV-1115 IP32 Air Vent Fan Dia 2.91" L x 2.76" W x 2" D, Gray

These vents were perfect for my outdoor pixel control boxes. Allowed for great airflow while preventing water / snow from getting in. Nice and sturdy strong construction, these are a little pricey but well worth the money.

I wanted to put a vent in my outdoor box that I have a Raspberry Pi running and this worked out nice. Nicely made and would buy again if needed.

I needed to vent an exterior electrical junction box. I bought 2, mounted one low, the other high, on opposing sides. Good quality, comes with a rubber o-ring for a better seal. I reordered another for a separate application. Would buy again.

I needed a simple passive cooling solution for my equipment boxes and these were not only a perfect size, but the price was spot on. Time will tell how well they last, but the quality seems pretty good.

Used this to vent an electrical box containing my solar setup. It was getting up to 118 degrees farenheit in the box and the inverter instructins say it's operating range is only up to about 120. Ideally it should be below 104. To install this I had to drill a 2.5 inch hole in the box with a hole saw. There was a lot of heat generated and the box melted around the cut. If you don't have rag handy you will have remove the meltage after it hardens. I put in a 60 mm fan using 4mm screws. I'm running the fan off the charge controller load. It was 100 degrees outside today and the box got up to 111 inside so the vent helped some.

Excellent product - tho for those not as skilled at these types of things it would be helpful to have a Q&A on product page or even show how the mount is supposed to house the fan. At first, I thought the fan was supposed to go inside the slot and was really annoyed when it didn’t fit. Then I finally saw the spec sheet and hated myself. Lol sometimes less isn’t always better when it comes to product example photos! :-) Thank you

could not use supplied "O" ring, box wall too thick to allow assembly

Solves a very select problem.Needs modified if you're after high flow.

Good quality build.Model IPV-1115Fits 60mm fanHoles are 50mm apartHoles are not threaded and are 3mm wideHolesaw required is 2 1/2”